Jump to content

Vds Préampli East J-Retro Deluxe Neuf Dans Sa Boite


Fractal-M.

Recommended Posts

Hello,

Je vends un préampli East J-Retro Deluxe neuf de chez neuf, dans sa boite jamais déballé, je l'avais commandé pour un projet et au final le U-Retro est plus adapté à ce que je veux faire donc du coup celui-là me reste sur les bras...

C'est la version pour jazz bass en full black, la plaque jb est incluse et elle est noir comme les boutons.

Je met une photo du chromé car je l'ai pas trouvé en black, après pour celui qui veut je peux le déballer et prendre une photo.

Le préampli vaut 270euro sur le site East (et 300euro chez FredGuitar qui est le distributeur exclusif pour la France) et j'en demande 220euro + fdp . C'est un préampli que j'adore et qui équipe presque toutes mes basses, pour moi c'est un des meilleurs du marché :)

jretro10.jpg

images11.jpg

J-Retro DELUXE

Same as J Retro, but with an added fourth knob for passive tone control. This preamp is made for Fender Deluxe style basses with a side mounted jack.

Technical

VOLUME & BLEND (Knob stack nearest the neck pickup)

VOLUME

The upper knob is the Volume which has two sections under the same knob. A high impedance for the passive path and a low impedance section is used for the active circuitry. When used active, this knob has active circuitry after it so that the feed to your amplifier is a low impedance drive.

BLEND & PICKUPS SWITCH

The lower outer knob is the Blend balance for the pickups. Turn it fully clockwise for the neck pickup alone and fully anti-clockwise for the bridge pickup. The midway position, which has an indent, gives an equal mix of both pickups. The balance between the pickups is continuously variable with progressive level compensation towards the single pickup settings. Important:- The Pickups switch (by the blend) must be set pointing towards the jack for the Blend to function.

BASS & TREBLE (The middle knob stack)

TREBLE (+12dB @ 3 kHz, -12dB @ 1kHz)

The upper knob is the Treble control with boost and cut. The central 'flat' position is indented. The cut settings work on lower frequencies compared to boost to give a deeper sound when the top is rolled off.

BRIGHT (+8dB @ 7kHz)

Pull the Treble knob for the Bright setting.

BASS (+15dB @ 50Hz)

The lower outer knob is the boost only Bass control. The frequency band of boost gets progressively lower as the boost is increased. An indent midway is included to aid the setting of this control.

MID LEVEL & FREQUENCY (The knob stack nearest the jack)

BOOST/CUT (+/- 12dB)

The upper knob controls the amount of Mid boost or cut at frequencies according to the setting of the Frequency knob. The midway indent is the 'flat' position.

FREQUENCY (150Hz - 3kHz)

The lower outer knob is continuously variable and sets the Mid frequencies for boost or cut.

PASSIVE TONE (single knob near the jack)

The passive tone pot consists of two sections, one for each pickup. Two sections are necessary since the pickup signals are kept separate end fed to their own individual input amplifier prior to the electronic blend circuitry.

To retain the characteristics of a true passive tone, its circuitry is connected directly to the pickups at all times and therefore function in both active and passive modes. The roll-off frequency is set to give a deep mellow sound.

ACTIVE PASSIVE SWITCH (By the jack)

Towards the jack for active, the opposite for passive.

POWER

The PP3 battery is switched on automatically when a mono jack is plugged into the socket.

POWER

The PP3 battery is switched on automatically when a mono jack is plugged into the socket.

Musicalement :)

Edited by Fractal-M.
Link to comment
Share on other sites

J'ai besoin de plus de précisions sur ce qu'il y a à faire exactement pour la modif. Combien de fils ? qu'est ce qu'on en fait une fois qu'ils sont déssoudés... ( étant une quiche en soudure )

Du coup je remets mon option.

Edited by gargouill
Link to comment
Share on other sites

×
×
  • Create New...